Showing all 14 results
FLIR 12V 4″ Blackbody Source for ALC & Supplemental FFC, offers a uniform temperature source for FLIR Tau 2 Thermal Cameras. Low cost 4-inch blackbody which provides a uniform temperature source when using FLIR’s Alt Lens Cal software to field-calibrate lens-less Photon or Tau cameras with third-party lenses, or to take advantage of the Supplemental…
Single USB interface cable for the Boson VPC with USB-C to USB-A Cable and BNC.
Single USB interface to Boson with USB-C to USB-A Cable
Boson USB / Analog Video Power Connector (VPC) Kit
Teledyne FLIR NFOV Lens Holder for the FLIR TAU 2 Thermal Cameras
The Tau Focus Tool can be used to change the focus of the wide field of view (WFOV) 5.5mm, 7.5mm, 9mm, 13mm, or 19mm lenses.
The lens locking ring is designed to mount a Tau WFOV camera into a bulkhead. The M29 x 1.0 thread on the outside of the lens mount flange is placed through the clearance hole in the bulkhead and the O-ring seals the camera to the face. The Type 2-025 O-ring is not for sale through…
The lock nut tool will attach to a torque wrench for proper tightening of the lens locking ring. Torque the locking ring to 4.0 in-lbs.
Full access to Boson 80-pin interface allows connection to:
Boson MIPI development board provides the option of a digital data protocol typical of a MIPI CSI v1.1, and DPHY 1.0 camera in a software configurable single or dual lane configuration.
NOTE: This test board is available for development purposes to fan out several of the interfaces provided on the primary I/O connector.
It is not intended to be integrated into final end-use products.
Design and fabrication of an additional interface board is recommended for non-development use cases.