board

Showing all 2 results

  • Teledyne FLIR Tau Photon Replicator Board

    Teledyne FLIR Tau Photon Replicator Board

    $165.00

    This expansion board adapts the Tau camera’s native 50-pin Hirose connector to the 30-pin SAMTEC connector used on FLIR’s Photon cameras. The replicator board makes the Tau camera electrically pin-compatible to a Photon camera. Without a Photon Replicator Board, the input voltage range is 4.0-6.0 VDC for a Tau 320 camera, and 4.4-6.0 VDC for a Tau 640. With the Photon Replicator Board, the input voltage range is modified to 6.5-27.0 VDC.

    * Includes spacer and screws

    This expansion board adapts the Tau camera’s native 50-pin Hirose connector to the 30-pin SAMTEC connector used on FLIR’s Photon cameras. The replicator board makes the Tau camera electrically pin-compatible to a Photon camera.

    Without a Photon Replicator Board, the input voltage range is 4.0-6.0 VDC for a Tau 320 camera, and 4.4-6.0 VDC for a Tau 640. With the Photon Replicator Board, the input voltage range is modified to 6.5-27.0 VDC.

    A cast magnesium spacer and 4 socket-head machine screws are included (not shown).

     

    Stock is very limited. There are only: 2 Units Left

    Add to CartDone
  • Teledyne FLIR Boson MIPI Development Accessory Board

    Teledyne FLIR Boson MIPI Development Accessory Board

    $407.00

    Boson MIPI development board provides the option of a digital data protocol typical of a MIPI CSI v1.1, and DPHY 1.0 camera in a software configurable single or dual lane configuration.

    • Pixel Formats:
      • RAW8 (monochrome, post-AGC)
      • 16-bit UYVY (color, post-AGC)
      • RAW14 (pre-AGC)
    • Single Channel Mode:
      • Monochrome 8-bit
      • Monochrome 14-bit
      • Post-AGC 8-bit monochrome
      • Post-AGC 16-bit color YUV422 (UYVY)
    • Dual Channel Mode:
      • Monochrome 8-bit & Monochrome 14-bit
      • Post-AGC 16-bit color YUV422(UYVY) & Monochrome 8-bit
      • Post-AGC 16-bit color YUV422(UYVY) & Monochrome 14-bit
    • MIPI DDR clock rate: 246 MHz
    • Latency: <4.8ms

    NOTE: This test board is available for development purposes to fan out several of the interfaces provided on the primary I/O connector. 
    It is not intended to be integrated into final end-use products.
    Design and fabrication of an additional interface board is recommended for non-development use cases.  

    Add to CartDone